AV Equipment - Room #402
TECHNICAL INSTRUCTIONS – Start / End the presentation
Start presentation
① Touch the Lectern Control Panel – it wakes up immediately
② Press the button “Press for local presentation” to start…
Left and Right projectors are turned on automatically, Lectern PC/Laptop is selected as a source of the presentation
During the presentation you may:
Turn ON/OFF the Side Display and then select its signal source (HDMI) (see column “Side Display” → “Power ON/OFF” + select signal source with “Present from”)
Adjust Master Volume and Mute sound (Slider at the right side of the Control Panel)
Turn the Lights and Shades ON/OFF (touch button “Lights & Shades” to see the sub-menu)
Adjust audio Setup to change sound levels of presentation etc. (touch button “Audio setup”)
End presentation
③ After your presentation, turn off the equipment:
Touch “Power OFF” button at the upper right corner (“Power Control” menu appears)
Touch “System OFF” button in the middle of the screen to completely shut down AV equipment
Finally turn off the presentation PC (placed in Lectern)
Reset EVERYTHING to DEFAULT
To reset to DEFAULT (start-up) setup: turn the System OFF, wait for 2 minutes and turn it ON again
Note: There is a 2 minutes cool-down period after you turn projectors off
(it is NOT possible to turn projectors ON again before they properly cool down)