Show pageOld revisionsBacklinksExport to PDFBack to top This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong. ===== Profile Configuration on MyQ Multifunction Devices ===== * Providing you have MyQ multifunction devices properly installed and fully functional, select (double click) ** MyQ ** in ** Devices and Printers ** pop-up menu option. * Select ** Printer ** and then ** Properties ** in pop-up menu {{:public:print:ky1.jpg}} * Select ** Device Settings ** if you want to use e.g. the staple {{:public:print:ky2.jpg}} * Select **Device option****s **and click OK {{:public:print:u22.jpg?nolink&539x516}} <WRAP round important 50%> Check that the finishing features can be used on the destination device </WRAP> * Go to ** General ** option and click on ** Preferences… ** to configure printing preferencies {{:public:print:ky4.jpg}} * In ** Basic ** option select ** Print size (A4 [100%]), orientation, duplex ** etc. {{:public:print:ky6.jpg}} * Select ** Finishing ** to configure e.g. ** Staple ** {{:public:print:ky5x.jpg}} * Configure ** Staple ** options and if you finished your configuration, select ** Save As… ** to save it as a ** Profile ** * The** maximum** number of **pages** that can be** stapled**: - Taskalfa printer third floor (corridor) - 65 sheets of A4 or 30 sheets of A3 - Taskalfa printer fourth floor (kitchen) - 50 sheets of A4 or A3 {{:public:print:ky7.jpg}} * Select a proper name for your profile and a proper icon click on ** OK ** to save it {{:public:print:ky8.jpg}} <WRAP round important 60%> If you want to use the profile, select it in ** Printing Preferences ** of the printer. </WRAP> CKG Edit /var/www/html/dokuwiki/data/pages/public/print/kyocera_profile.txt Last modified: 2018-03-27 14:09by jbozdech