Differences

This shows you the differences between two versions of the page.

--- public:print:kyocera_profile [2017-04-05 09:52] – krest
+++ public:print:kyocera_profile [2018-01-05 12:42] – mam
@@ Line 1: / Line 1: @@
 ===== Profile Configuration on MyQ Multifunction Devices =====
-  * Providing you have MyQ multifunction devices properly installed and fully functional, select (double click) ** MyQ ** in ** Devices and Printers **  pop-up menu option.
+  * Providing you have MyQ multifunction devices properly installed and fully functional, select (double click) ** MyQ **  in ** Devices and Printers **  pop-up menu option.
   * Select ** Printer **  and then ** Properties **  in pop-up menu
 {{:public:print:ky1.jpg}}
-  * Select ** Device Settings **  if you want to use e.g. the inner finisher
+  * Select ** Device Settings **  if you want to use e.g. the staple
 {{:public:print:ky2.jpg}}
-  * Select ** Inner finisher **  and click OK
+  * Select **Device option****s **and click OK
-{{:public:print:ky3.jpg}}
+{{:public:print:u22.jpg?nolink&539x516}}
+<WRAP round important 50%> Check that the finishing features can be used on the destination device </WRAP>
   * Go to ** General **  option and click on ** Preferences… **  to configure printing preferencies