Differences

This shows you the differences between two versions of the page.

--- public:print:kyocera_profile [2017-03-15 15:05] – krest
+++ public:print:kyocera_profile [2018-03-27 14:09] (current) – jbozdech
@@ Line 1: / Line 1: @@
-===== Profile Configuration on Kyocera CS 3252ci KX Multifunction Device =====
+===== Profile Configuration on MyQ Multifunction Devices =====
+  * Providing you have MyQ multifunction devices properly installed and fully functional, select (double click) ** MyQ **  in ** Devices and Printers **  pop-up menu option.
+  * Select ** Printer **  and then ** Properties **  in pop-up menu
+{{:public:print:ky1.jpg}}
+  * Select ** Device Settings **  if you want to use e.g. the staple
+{{:public:print:ky2.jpg}}
+  * Select **Device option****s **and click OK
+{{:public:print:u22.jpg?nolink&539x516}}
+<WRAP round important 50%> Check that the finishing features can be used on the destination device </WRAP>
+  * Go to ** General **  option and click on ** Preferences… **  to configure printing preferencies
+{{:public:print:ky4.jpg}}
+  * In ** Basic **  option select ** Print size (A4 [100%]), orientation, duplex **  etc.
+{{:public:print:ky6.jpg}}
+  * Select ** Finishing **  to configure e.g. ** Staple **
+{{:public:print:ky5x.jpg}}
+  * Configure ** Staple **  options and if you finished your configuration, select ** Save As… **  to save it as a ** Profile **
+  * The** maximum**  number of **pages**  that can be** stapled**:
+- Taskalfa printer third floor (corridor) - 65 sheets of A4 or 30 sheets of A3
+- Taskalfa printer fourth floor (kitchen) - 50 sheets of A4 or A3
+{{:public:print:ky7.jpg}}
+  * Select a proper name for your profile and a proper icon click on ** OK **  to save it
+{{:public:print:ky8.jpg}}
+<WRAP round important 60%> If you want to use the profile, select it in ** Printing Preferences **  of the printer. </WRAP>
-  * Providing you have Kyocera CS 3252ci KX multifunction device properly installed and fully functional select (double click) this device in ** Devices and Printers ** pop-up menu option.
-  * Select ** Printer ** and then ** Properties ** in pop-up menu
-    {{:public:print:ky1.jpg|}}
-  * Select ** Device Settings ** if you want to use e.g. the inner finisher
-    {{:public:print:ky2.jpg|}}
-  * Select ** Inner finisher ** and click OK
-    {{:public:print:ky3.jpg|}}
-  * Go to ** General ** option and click on ** Propertie ** to configure printing preferencies
-    {{:public:print:ky4.jpg|}}
-  * In ** Basic ** option select ** Print size (A4 [100%]), orientation, duplex ** etc.
-    {{:public:print:ky6.jpg|}}
-  * Select ** Finishing ** to configure e.g. ** Staple **
-    {{:public:print:ky5x.jpg|}}
-  * Configure ** Staple ** options and if you finished your configuration, select ** Save As... ** to save it as a ** Profile **
-    {{:public:print:ky7.jpg|}}
-  * Select a proper name for your profile and a proper icon click on ** OK ** to save it
-    {{:public:print:ky8.jpg|}}